MXD4000 Digital Preamp Processor
The Myryad MXD4000 Digital PreamplifierÂProcessor has been designed to offer a combination of high quality audio and video performance with simple yet elegant styling. The MXD4000 forms the heart of a highÂend home cinema.
- Digital-to-analogue conversion: 8 channels, delta-sigma, 24bit 192kHz
- Analogue-to-digital conversion: 2 channels, delta-sigma, 24bit 96kHz
- Stereo sources may be sampled at 48kHz or 96kHz as desired
- 24bit 96kHz capable digital inputs
- Three HDMI digital video inputs - each assignable to any of ten sources
- Three component video inputs - each assignable to any of ten sources
- Six composite video and four s-video inputs - each assignable to any of ten sources
- Video transcoding (with OSD available on transcoded
video):
- Composite to S-Video - Composite to component video (Y/Pb/Pr)
- S-Video to component video (Y/Pb/Pr) - Simple intuitive menu system for setup
- Comprehensive bass management:
- Hybrid digital/analogue bass management optimises dynamic range under all
conditions
- Crossover frequency can be set between 20Hz and 200Hz in 5Hz steps
- Subwoofer can be fed a 'flat' signal to allow the sub's own filter to be used - 7.1 channel analogue bypass input
- Analogue domain bass management on 7.1 channel input Options: all Large,
only LF/RF Large, or all Small. HPF crossover fixed at 80Hz, 2nd order - Loudspeaker distances can be set in feet or metres
- Lip sync correction (audio delay up to 150ms)
- Five separate preset setups (speaker levels, bass, treble and lip sync) can be stored
and assigned to specific sources - Stereo analogue input sensitivities individually adjustable
- Analogue Monitor allows metering of stereo input signals levels - with automatic
setting of sensitivities if desired - Comprehensive control of remote trigger outputs from a wide variety of controlling
sources - Supplied with Universal Remote Controls' MX-700 remote, pre-programmed with all
Myryad remote codes - including 'discrete' codes not sent by other Myryad handsets. - RS-232 interface can be used both to control the unit and to carry out the setup
- Two Xantech-compatible IR input jacks
- Second zone output: stereo audio plus composite video
- Smart My-Link® communications to other Myryad products
